Otherwise take a look at the link under the Resources section at the bottom.
I think this process would work on Windows too, as long as it has Python 3.2 or later. Note that I have a Mac (running Mojave OS at the time).
I soldered them on top, but consider soldering them on the bottom for aesthetic reasons. USB-to-TTL Serial Cable which you can get from Adafruit or Amazon.Ĭut off 4 headers and solder them on the kit's board, next to the red LEDs where labled P31, P30, GND, VCC.Here is what I did to get it working: The Hardware 💩 The chip in the kit is supposed to come with the code pre-loaded, however as I discovered that was not the case. It came without instructions, but luckily there are pleanty of good tutorials on the internet such as this one.Īfter soldering all the components and testing with 8 LEDs, only 3 of them light up and there are is no animation, as seen in this video: I got this Geekcreit® 8x8x8 LED Cube 3D Light Square Blue LED Electronic DIY Kit from Banggood ("the kit"). A process to update the firmware on a Geekcreit® 8x8x8 LED Cube 3D Light Square Blue LED Electronic DIY Kit and get it cycling animations, using a Mac OSX.
0 kommentar(er)
